Zoom 56k usb modem model 3095 update#
Zoom 56k usb modem model 3095 full#
Zoom 56k usb modem model 3095 Pc#

Stuff or any configuration data and this time when I called from my cell phone, the correct caller-id number showed instantly in the mgetty log file. So I shutdown mgetty, unplugged the Zoom modem and connected the TrendNET modem, then restarted mgetty. So other then the 15 Zoom USB modems I already purchased for a project, I have 2 or 3 TrendNET USB Modems.

Zoom 56k usb modem model 3095 update#

Post updated at 04:46 PM - Previous update was at 03:51 PM.

Zoom 56k usb modem model 3095 Pc#

So both my laptop and the PC running Mgetty both have DID numbers assigned to them.Īlso, if I call the mgetty PC from my cell phone, I can see my cell number on the dumb phone's Caller ID but mgetty shows it as 'none'. And when I make the call I can see the dumb phone ringing with the correct caller ID number as well as I can see mgetty Ringing while watching the log file. Yes, I have one line coming out of the ATA and going into a splitter and from that splitter one end goes into the PC running mgetty and the other end goes into a dumb phone that has caller ID.

Zoom 56k usb modem model 3095 full#

I'm really confused why it works for 4-digit extension, but not a full 10-digit phone number?ĪNY thoughts or suggestions AT ALL would be greatly appreciated!Īre you sure the number you calling into has DID (direct inward dial) capability, in other words can you make a call to that number (where mgetty is) from the outside and have it answer? Number to nfig and called the mgetty PC from my cell, and that also displayed in the mgetty log as 'none'.Īnybody have any idea what could be going on here. Thinking that maybe the issue was with the External Phone number mask that gets assigned when it leaves my building, I added my cell phone So I'm really confused as to why the Caller-ID is showing as 'none' when there is a phone number present for So when I dial the mgetty PC I can see mgetty is RINGING in the log and that the dumb phone I know that the Caller-ID is displaying correctly because before the phone line goes into the USB modem it is attached to a splitter and the otherĮnd is connected to a dumb phone with Caller-ID on it. Mgetty to take the new config and now when I dial to mgetty it is no longer accepting my call and mgetty is saying the Caller-ID is 'none'. What I did was I added the full external Phone Number Mask to the nfig file for what my laptop will display after it leaves my building. where the call actually leaves the building in order to reach the PC running mgetty. Inside nfig it would ONLY issue a CONNECT to my laptop' extension and I could remotely login to that PC over dialup. If I put the extension my laptop was using

Tests were internal the Caller-ID was showing up as 4 digit extensions. The testing I was doing was internal using a Cisco ATA 186 with 2 phone lines (*one to my laptop and one to the PC running mgetty). Which tells mgetty what calls to answer using the Caller-ID. I had to recompile mgetty from source so I could enable support for the nfig file Using minicom (*minicom -dials to-> mgetty). So I've been playing with mgetty for weeks now testing dialing into the USB modem from another PC using the same modem and connecting